The Pi will not boot from the SSD when the identical SSD drive is inserted inside the  Block Blast NASPi after the video. 

x-c1 script are now obsolete. Any solution are welcome.  

I have a NASPi X823 V2.0 with 8GB Pi ver 4B. I have created a bootable 2TB 2.5" SSD that works fine as a USB drive when plugged into the lower USB3 port. When the exact same SSD drive is installed ...

according to a thread is is supost to work, but it doesnt its a scam

@Wouter van de Pol    Sorry for not replying to you due to the Chinese New Year holiday. Glad to see that you have solved the problem. Pikvm outputs edid to the target host for adjust...

How about running lsusb without the M.2 drive installed, swapping USB cables/ports, and using an externally powered USB hub to rule out power issues? 

The feasibility of using the X1009 for your project depends on its firmware flexibility and access to low-level SATA command handling. If the X1009 allows custom firmware development or provides an...

Hi, I'm not sure if this is the correct way to fix this issue, but I also realized that I might have forgotten to reboot the server, which could have caused the resolution to stay the same. So per...

Hello, I am using the Geekworm X680, which I purchased in June 2024 (so I assume it is version 1.5), with Pi-KVM and attempting to capture video at 1920x1080@60Hz. While the device claims to suppo...

 I did find something that might point to a bad USB bridge though. I found these logs in dmesg: [739264.653595] usb usb2-port2: Cannot enable. Maybe the USB cable is bad? [739268.733541] usb...

So I'm trying to figure out if my M.2 drive I got is bad, or if the board or USB adapter that plugs into RPi and x862 board is bad.Does anyone know if the Pi detects the x862 when plugged in with t...

Your setup requires a solution to switch between HDMI and the 30-pin LVDS arcade board for your 4K BOE MV315QUM-N20 monitor. Unfortunately, 4K-compatible LVDS to HDMI converters are rare, and most ...

The X1003 NVMe shield should be compatible with the RP5 and the official 512GB NVMe, but issues like power delivery, firmware, or thermal management could cause instability.

@PolyTrack In some cases, the PiCore or Raspberry Pi OS may have a software configuration related to power delivery over the USB ports. You can try reconfiguring or checking the settings related to...

I checked out your products and saw a few things that may work for what I'm looking for but need some guidance if possible. I have a arcade type machine that has a 32 inch 4k monitor with 30 pin l...

Hi, Sorry, we don't provide free shipping, you can also consider to order from amazon if they are available on amazon, thanks!

You could add PWM control to the existing fan it you are comfortable with a little re-wiring. https://github.com/agspoon/PiKVM-PWM-Fan  

Finally got around to writing all this up. https://github.com/agspoon/PiKVM-PWM-Fan

I believe that GPIO 12 is also available for PWM. I've used it for a while now with no issues. https://github.com/agspoon/PiKVM-PWM-Fan

Hi may I ask is there any free shipping? Thanks