It's always helpful when people post both the symptoms and the exact steps that resolved the problem. Hopefully this saves others from spending hours swapping cables, power supplies, and PCs before...

I think i may have found a fix. In the shutdown script, before calling the Raspberry Pi 4 to turn off, set the GPIO26 pin to input. It seems to have fixed the problem for me. I am still further tes...

This is a super interesting question! I'm also curious about combining auto power-on with a momentary switch for graceful shutdowns. Hopefully, someone with experience using the X735 can help you n...

This is fascinating! I'm always impressed by how technology evolves, especially in niche areas like this. It reminds me of the constant updates and improvements you see in gaming, where even a slig...

I ran the x728 on OpenWRT as well, and in my experience the low-voltage shutdown and auto power-on worked reliably only after I updated the Python scripts for Python 3, so I'd definitely recommend ...

https://lovescape.com/categories/ebony stands out for its attempt to create a persistent AI identity that carries across sessions. This makes conversations feel less fragmented and more connected. ...

It sounds like the X1202 may be entering a power state that it can't recover from properly without a full power cycle. I would check the power supply stability and any auto-shutdown settings, since...

Any problem?

Good catch. In my experience, when the CM4 appears as `RPI-MSD -0001`, flashing can be hit-or-miss depending on the host system. Using the full rpiboot setup with the required submodules often reso...

Hello, It flat top 18650 batteries.

It looks like your Pi is detecting the ASM1182e PCIe switch on the X1004, but neither NVMe drive is enumerating behind it, which usually means the HAT isn’t getting proper PCIe link training ...

If your KVM switch connects to the front panel headers of the Raspberry Pi, it may support power on/off functionality through the GPIO pins. However, you would need to verify the specific model&rsq...

Those temps (around 45–55°C idle) are normal for NVMe drives, especially in compact setups with limited airflow. The variation you see is mostly due to controller efficiency and NAND type...

Using an X1009 together with one or two UPS1 boards should work electrically, but the main limitation is how the UPS1 modules share load and charging current. If both UPS1 units are connected, you&...

We cannot guarantee that the ice tower fan will be compatible with it.  

I ran into something similar with the X728 on a Raspberry Pi 4. In my case the issue was related to how the shutdown script interacted with the power management on GPIO 26. If the script fully powe...

I am looking for a solution to housing a Raspberry Pi5 with the Pi AI hailo8 hat and a sata ssd drive.  I have everything but the X1100 Shield (usb version) and the X1100-C1 metal case, but I ...

If the HAT is essentially a USB-to-SATA bridge and only relies on a functional USB 3.x connection, it should work with other SBCs like Rock Pi 4B or Odroid N2. The main limitation would likely be t...

yea from what i can figure out that if you do a graceful shutdown the "auto_on" doenst work. prob something to do with what state a register is being left in . I have tried different pulses and etc...

Does the X1201 UPS use "button top" and "flat top" 18650 batteries?