There's no way to install with brackets, I can install the board alone, what I wasn't sure is the ATX pins but I found them, they are 2mm so I have to get a 2mm female cable/s. I will try anyway.

@Virginia Gonzales  The dimensions of the reference X630-A5 are as follows:

@Virginia Gonzales  We didn't really test it against an NUC, and we doubt you'd be able to install the X630-A5 into a NUC case, although the X630-A5 also comes with a half-size mounting bracket.

Is the forum alive?

Thanks. I requested a replacement cable.  

Hi! I want to order a PiKVM-A3 kit to manage my Intel NUC NUC11PAHI7. Anybody has tried and knows a success story for Intel NUC? I can't seem to find the ATX pins on the NUC motherboard..., never ...

Hello.I think you are right, that PCIe cable may be defective, we recommend you to replace the cable (please pay attention to the direction), or contact Geekworm support team (support@geekworm.com)...

I recently purchased an X1002 and P580 case (on Amazon) with a view to creating a NAS on a Raspberry Pi 5.  I paired this with a Crucial 4TB NVME 2280.  (Yeah, I now know about the 2TB li...

thank you Harry.

@Bruno de Carvalho Sorry, there is no switch to turn off the LEDs.You can get a piece of tape to cover it.

Hey guys, is it possible to disable blue light from flashing all the time? I know it indicates disk operation but at night at my office its completly annoying. And I have 5 of this. It would be gre...

Geekworm device does not work. I need direction to make it running as expected.

Disclaimer: We do not accept any offers to publish sponsored or advertising articles on our website.   Thanks.   Geekworm.com

x708 Working principle (from https://wiki.geekworm.com/X708) The GPIO13 is used to control the power button, It goes high for 3 seconds that means the power switch is pressed and held for 3 second...

Hi! I’m using X708 v2.0 uninterruptible power supply expansion board with Raspberry Pi 4 (Raspbian Buster 11.9, Linux 6.1.21-v8+ aarch64), with the latest X708-script from github installed, a...

Finaly I put one hd disk into an sata to usb interface. I was able to do all the step of "How to Boot Raspberry Pi 4 / 400 From a USB SSD or Flash Drive" and boot my PI 4B from USB. Putting that d...

How to Boot Raspberry Pi 4 / 400 From a USB SSD or Flash Drive : step 1-8 on PI 4B alone ( if not pi does not boot ) before step 9 : mount pi on x882 board and connect x882 to gpio step 9 : Into...

PI 4B is configured to boot frolm SD card. During my test  I detect than connecting GPIO to X882 prevent PI 4B from booting. Any direction is welcome. I am reading your recommendation, but ...

Hello Refer to How to Boot Raspberry Pi 4 / 400 From a USB SSD or Flash Drive  

Hello. Powered by geekworm 220v~/12v= 5A PI 4B is powered (red light on) Never boot (green light always off, never blink) Screen is black.   Alone PI 4B run normally. Any help is urgent...