@crazy cattle 3d I’ve seen a few people swap the stock fan for a quieter 40mm Noctua or Sunon with good results. A heatsink alone might not be enough depending on your ambient temps, but a la...

Have you tried a different USB OTG cable or adapter between the Pi and the x306? Sometimes the data lines don’t get picked up if the cable is charge-only. Also worth checking if the overlay i...

@ deer adventure If the KVM-A3 itself is working fine but the OLED never powers on, it could be a firmware/config issue rather than a bad connection. A couple things to try: Make sure you&rsq...

@slope Yes, you're correct that the X728 is designed to provide a battery backup and safely shut down your Raspberry Pi in case of a power outage, ensuring it can reboot when power returns.

I know. The pi works for 1-2 days. That is th reason, why I think that it is no problem with the contacts. I will try to reconnect the pi to the the X1202.  I am considering replacing the pla...

Please note: If the UPS does not detect the RPi5, it will automatically shut down within 3 seconds. So you need to install the RPi 5 on the UPS and make sure that the RPi5 has good contact wit...

Hello, my raspi 5 and the X1203 works. The voltages are ok and I have connection via i2c. Every day the raspi is down. There are no entries in the logs. On the X1202 the led 5V and Pi are off. I...

Found some information and got it working: Set file system to read/write with rw Added this to /boot/config.txt:dtparam=i2c_arm=on Then did this:echo i2c-dev | sudo tee /etc/modules-load.d/...

Recent purchase of KVM-A3 device, set it all up with a downloaded OS.  Everything seems to be working ok, and I can view and control a PC connected to KVM-A3, the only issue us that the 0.96" ...

Hi i have a raspberry pi5 with an x1009, i only attached 1 drive, im using a 12v 5a power source meant for LED lights, i can see the x1009 doing lspci, but the disk wont spin and the blue light als...

@geekworm Sorry, X1202 does not support your idea.

@Snow Rider 3D I ran into the same confusion with a UPS HAT (not sure if it was V3), and the GPIO mapping tripped me up. On my Pi 4, GPIO6 (BCM) wasn’t the same as physical pin 6, and the wik...

Apologies if this is obvious, but I haven't managed to come across anyone doing so as yet -   Given I'll be pushing my Pi5 fairly hard, I was hoping to install the Geekworm X1202 UPS board a...

@ragdoll hit Hey, I've been testing on the X1004 board too and noticed similar temps—around 50–55°C idle for some NVMe drives isn't unusual, especially without dedicated heatsinks o...

To control the ATX power for servers connected to an X680 using Redfish, follow these steps: Check Configuration: Ensure the X680 is set up to recognize multiple nodes. If only ID 0 is visible...

That’s a great breakdown — built-in lens protectors really do make a difference. I like how Zapvi integrates them without compromising camera quality or adding extra bulk. @ball orbit ...

114

 Double-check power supply requirements and ensure the bootloader (e.g., EEPROM) is up to date. Also, verify PCIe lanes are enabled in firmware—some boards need specific overlays. @Monke...

I’d suggest testing the NVMe drive in another system if possible to rule it out. @doodle jump

How would you like to assemble them?