It’s best to check if the X1003 NVME shield is fully compatible with the RP5's 512GB NVME drive. Freezing issues might stem from driver conflicts, firmware mismatches, or hardware compatibili...

@ word hurdle The PiKVM-A8 is a powerful KVM-over-IP solution.

In got it. Thanks admin @play space waves

@speedstars This solution is the best to protect your Pi and SSD

I just bought a Raspberry Pi. I'm installing headless and creating an AI, primary purpose is not image manipulation/identification.The RPi 5 boots fine from the SD card. I can't seem to read/write ...

I never expected to meet someone who shares my love for retro gaming, but bisexual hookup made it happen. I was chatting with someone about classic arcade games, and it turned out they also had an ...

I have to give up, but I assume it's partly due to that I use a Crusial P3 disk that do have a Phison controller. For me, the hat (x1001) seem to be very sensitive for RF interferance. I got it mo...

Hey Tom, It sounds like the X735 isn’t passing power through to your DAC, which makes sense since the Pi typically powers HATs through the GPIO pins. Adding the X735 might have interrupted t...

That EDID length error is definitely a red flag—it seems like the EDID data got corrupted or isn't being read correctly by PiKVM. A couple of things you can try: Manually Reset EDID &nda...

Hey there!level devil I’ve been using a similar PiKVM setup, and getting audio to work bi-directionally can be tricky. Here are a few things to consider: USB Audio Passthrough – T...

The Pi will not boot from the SSD when the identical SSD drive is inserted inside the  Block Blast NASPi after the video. 

x-c1 script are now obsolete. Any solution are welcome.  

I have a NASPi X823 V2.0 with 8GB Pi ver 4B. I have created a bootable 2TB 2.5" SSD that works fine as a USB drive when plugged into the lower USB3 port. When the exact same SSD drive is installed ...

according to a thread is is supost to work, but it doesnt its a scam

@Wouter van de Pol    Sorry for not replying to you due to the Chinese New Year holiday. Glad to see that you have solved the problem. Pikvm outputs edid to the target host for adjust...

Hi, I'm not sure if this is the correct way to fix this issue, but I also realized that I might have forgotten to reboot the server, which could have caused the resolution to stay the same. So per...

Hello, I am using the Geekworm X680, which I purchased in June 2024 (so I assume it is version 1.5), with Pi-KVM and attempting to capture video at 1920x1080@60Hz. While the device claims to suppo...

 I did find something that might point to a bad USB bridge though. I found these logs in dmesg: [739264.653595] usb usb2-port2: Cannot enable. Maybe the USB cable is bad? [739268.733541] usb...

So I'm trying to figure out if my M.2 drive I got is bad, or if the board or USB adapter that plugs into RPi and x862 board is bad.Does anyone know if the Pi detects the x862 when plugged in with t...

I checked out your products and saw a few things that may work for what I'm looking for but need some guidance if possible. I have a arcade type machine that has a 32 inch 4k monitor with 30 pin l...