@Maurizio Imperatrice thank you! The `PCIE_PROBE=1` parameter was key for getting me to a point where the device would boot from NVMe. It worked! For a moment... --- I have the X1001 board and se...

@JinGyu Choi Were you able to get this to work?  I'd like to do this as well.

Hello. I appreciate your engagement with the X680 and ATX modules discussion on the Geekworm community forum. It's fantastic to see users collaborating and sharing insights.If you're ever in need o...

1. In fact, the pi 5 will boot from sd card even  if you still insert the TF card. 2. The PI 5 BOOT_ORDER  configuration is stored on the EEPROM of the PI 5 motherboard, and it not be ch...

Seems I solved the issue! In another guide I found another line to add to rpi-eeprom-config, this is what I did: sudo rpi-eeprom-config --edit Added as the first line of the file PCIE_PROBE to...

On December 15 I bought on Aliexpress "X1001 M2 Shield". Everything works fine if I boot from SD, but I can't boot from SSD. I followed your procedure on this page: https://wiki.geekworm.com/NVMe_S...

When selected, the switch turns green.

nano /etc/kvmd/override.yaml kvmd: gpio: drivers: switch_input_1: type: cmd cmd: [/usr/bin/bash, /etc/kvmd/scripts/switch_input.sh, 1]...

Hi Not sure if i understand correctly but what i need to do for my Geekform PIVKM to act like mouse and keyboard.  I have not plugged anything to OTG and not quite sure if i need to plug some...

a couple of years ago i bought a geekworm  ssd expansion board which came with that usb connector.  that connector inspired me to find a similar u shaped usb adapter to use with my new KV...

Discover cutting-edge EdTech tools at EduTechBuddy. Elevate your learning experience with their dynamic range of educational resources. Visit now to unlock a world of possibilities in education and...

I created a new topic with my very similar problem here: https://geekworm.com/community/forum/topic/119225/kvmd-fan-not-functional-with-pikvm-a3 Enabled kvmd-fan but it does not limit my fan speed.

I installed the KVM-A3 and so far it works fine. One thing that does not work is the fan control. The fan is always spinning on high velocity, creating a lot of noise. I enabled the fan control l...

@brix maxx I'm actually working on this right now.  I'm the original poster and for some reason can't put new replies on my old account so I started a new one.  While I don't have the ori...

@Mark Berndt This is great.  Any chance you think there's a way to also make the PC Input dropdown show LEDs that indicate which input is selected?  Looks like your sciprts only pass CTRL...

@Harry Huang  1) Can the input be switched thru a GPIO command (and not just ctrl-ctrl-x)? The PC input can be switched via the GPIO webterm menu feature of PiKVM: add the following to /etc...

Hello, how much latency can i expect from the HDMI to CSI-2 Module with Toshiba TC358743XBG chip C790 ? Thank you

I need to build a harness to mate with the "+5V IN" connector on my X703 UPS. Does anyone have connector and contact part numbers?Thanks

Yes, the input can be switched through a GPIO command. In Raspberry Pi, you can use the GPIO utility to manipulate the pins and switch the input/output mode. For example, in PSUControl switching sy...

The auto power on function has nothing to with switch. trasteros barcelona