I already checked connections 4 times by disassembling it. I cleared the connections with rubber, even though they are very clean because my Pi is only one year old. I also sent logs confirming ic2...

Hello   1. Make sure you enable i2c interface, refer to How to enable I2C 2. The UPS connects to the Pi GPIO via pogo pins, If the I2C address (0x36) is not detected, Please clear the ...

After installing fresh new X1200 UPS I can't get any status code from i2cdetect: i2cdetect -y 1 0 1 2 3 4 5 6 7 8 9 a b c d e f 00: -- -- -- -- -- -- ...

Hi  AllRecently got a X1201 and X1202, before installing the batteries to the UPS, do i have balance all batteries to be same voltages before installing to the UPS ? Will the UPS manage e...

Great setup, Pierre! You're right—the X728 is the better choice for safe shutdowns and battery backup. I’ve been through a similar situation while running Space Waves sessions on my Pi&...

can't solve it

It sounds like you're having trouble with your X630 HDMI to CSI-2 capture device. The red LED and the fact that the video isn't being detected suggest a problem with the device itself. Since the pa...

@Sprunki Retake I also encountered the same problem with the X630 HDMI to CSI-2 device—the red light was always on and no video was received, even though I followed the video instructions exa...

I actually ran into a similar issue a while back with a Dell R640 server and a network card. Even though the card was advertised as half height, the bracket was just a bit off and wouldn’t se...

I am also looking for similar ideas @Survival race

Great to hear about your positive experience with the Pi5 X1001 Shield and aluminum case! It sounds like a perfect upgrade! @Traffic Rally

No one has any idea? How do I get the attention of Geekworm themselves?

Issue solved, there was an error in my code. Many thanks

I've installed the Raspberry 4 on NASPI V2.0. According to the video, the fan should be working, but not in my case. I've tried a Python script without success. Then I installed the Geekworm Xscrip...

Hey, I am using the https://geekworm.com/products/pikvm-a3 I ran into a strange issue after I upgraded my mobo. The HDD LED in the web interface gets correctly lit only for the first few secs af...

cool! 

Is possible to use auto power on and internal (in case) momentary switch together? Need auto power on for powering and momentary switch for shutting down. I know, that in documentation of 735 is:...

That's an interesting issue! Could it be a power draw problem at startup, perhaps exceeding the Pi's USB current limit initially? I wonder if using a powered USB hub for the SkyConnect might allevi...

Hello guys, I have a raspberry pi 3b paired with an x820 board (with a 120gb SSD) which hosts my home assistant instance. Recently i bought the original usb zigbee dongle sold by home assistant, s...

Hello, I'm attempting to set up a Geekworm TC358743XBG HDMI-CSI-2 with PiKVM. Currently, I’m getting a "no signal" message when trying to connect. Upon checking the logs on my Ubuntu server,...