Apologies if this is obvious, but I haven't managed to come across anyone doing so as yet -   Given I'll be pushing my Pi5 fairly hard, I was hoping to install the Geekworm X1202 UPS board a...

@ragdoll hit Hey, I've been testing on the X1004 board too and noticed similar temps—around 50–55°C idle for some NVMe drives isn't unusual, especially without dedicated heatsinks o...

To control the ATX power for servers connected to an X680 using Redfish, follow these steps: Check Configuration: Ensure the X680 is set up to recognize multiple nodes. If only ID 0 is visible...

That’s a great breakdown — built-in lens protectors really do make a difference. I like how Zapvi integrates them without compromising camera quality or adding extra bulk. @ball orbit ...

114

 Double-check power supply requirements and ensure the bootloader (e.g., EEPROM) is up to date. Also, verify PCIe lanes are enabled in firmware—some boards need specific overlays. @Monke...

I’d suggest testing the NVMe drive in another system if possible to rule it out. @doodle jump

How would you like to assemble them?

Hello No possibility  

It's a bummer that the X630-A4 can't be adapted for the Raspberry Pi 4.

@slope Not exactly like the Pi 5 yet. Most Pi 4 NVMe cases are plastic or have limited passive cooling. 

hello

hello

Hello, I am curious where I might be able to source the 2 or 4 wire pigtails that plug into the 5v in/out and momentary switch on the x735.

@monkey mart This update has solved some compatibility problems.

Thank you for your quick reply. I am using a Pi 4 and found the x735 while looking to replace Mausberry Circuit's 4amp Car Supply / Switch. It failed on me and I believe many others and is not avai...

I saw that you bought X729, so I guess you are using it on RPi 4. Since X728 only supports DC 5V, you bought X729 which can support 12V input, which is correct. Thank you for your support.

Hello X735 definitely does not support the power failure detection and safe shutdown you mentioned, because X735 is not a UPS shield. It will stop working immediately after the power failure. You ...

I recently purchased a x735 because I was under the impression that it could detect power loss and initiate a safe shutdown. After installing it I have noticed this is not the case. Now I am trying...

I'm using the bat.py script to shutdown the Pi5 as soon as power is lost, rather than waiting for the depletion of the battries, but when power is restored, it will not turn the Pi back on.  I...