Thanks for the response.  I want to clarify what I saw (and still see although less often). When I first posted my Pi was on my desktop as I was reconfiguring it so it was only conected to a ...

We do not recommend using VGA to HDMI or DP to HDMI wire to provide HDMI signals to the X650, especially VGA to HDMI wire, which will result in no signal.

Ok final update. I guess the HDMI on my card is the only thing wrong (at the moment). For anyone who wants to know, its a "Zotac Gaming GeForce GTX 1660 OC". I had an extra DP to HDMI and its curre...

Scratch all of that. After testing yet again, it looks like the HDMI port on the video card has gone out and was going out, JOY!!! I plugged in my retro scaler and it gave me a signal on the x650. ...

So reflashed and flashed an older version. Both do not work and keep getting no signal. HDMI checks fine with a monitor so I have now idea whats going on other than a possible hardware issue with t...

It was purchased via Amazon (Link to item). I don't think its a flash issue and I have tried a couple of different V3 images that all do the same, no signal. I'll try another full download/flash an...

Since X650 V1.5, we have used the same pcf8563 RTC chip with PiKVM official hardware, so you don't need to do anything, the RTC will work fine. I don't know where you purchased our product fro...

Sorry for the late reply. Today, we tested X1203 and the results are as follows: 1: This is a full picture of the test. Please excuse my messy desktop.   2. There is no power supply to ...

The x650 is prefect for my needs but having issues with. First, I cannot get this to thing to work with any video at all. I have tried just about everything but use a custom EDID. Running dmesg | ...

I was thinking more a way the Pi measures the voltage source and, since it is not coming through the USBC connector, the measurement is not valid - but this is just wishfull thinking I admit. ...

I'll have to check the pogo pins on mine.  A very possible cause.

I switched out the approved power supply for an 18v 6a to try this and  I still get some (although I don't think as many) low voltage warnings.  I've sent a direct support message to Geek...

Same problem.  12.2 volts to the UPS  and same low voltage warning Pi5

@coreball It sounds like the power draw from charging and running the Pi + SATA HAT is overwhelming the board. You might need to limit charging current, reduce disk access during charging, or upgra...

 X1203 with two x 2 battery packs on Pi5.  I'm seeing voltage drops to the Pi under various loads that will drop to 4.9 or so and often trigger the Pi Low Voltage threshold warning. ...

@Alex Smart We have no experience in processing the HDMI source through TC358743 and then streaming it into another display. But it seems that you can use X1301 to see the current input source sig...

Im strarting with X1300 and wiki article was very useful, I managed to save a file from HDI input. However I want to stream HDMI input directly to Raspberry display (currently HDMI) and have no luc...

I understand, but maybe the 12V input power connector is directly connected to the 12V power connector for powering the drives and it doesn't matter where the power is connected.These two connector...

@drew drew No, it's 12v for OUT HDDs

Can I use the Sata power connector as a 12V power input for the Shield and Raspberry Pi 5?