@togetherthinking13 Do you know if the latency will be reduced if the input hdmi stream is monochrome rather than color?

Hello   https://forums.raspberrypi.com/viewtopic.php?t=35689&sid=b81b52309b0c46e76de2a5dad1c18ac7  

I managed to capture the csitest.yuv file if I change the format to UYVY but when I try to play it is says that the file is corrupted. 

Hi, I managed to set the format to 1920x1080@50  however when I try to capture there's an error occur which tells me select timeout.

Please set the HDMI signal source to 1920@1080P and try again. I just tested it again, using my laptop as the hdmi signal source. Once I set the resolution of the laptop to 2880@1800, the output r...

  @escape road 2 If your KVM switch connects to the front panel headers of the Raspberry Pi, it may support power on/off functionality through the GPIO pins. However, you would need to verify...

Even if I changed to the 1080P50EDID the format still seems to stuck at 1280x720, after I rebooted both the source device and the device mounted with X1301.

TechnologyAwareness.org is a valuablehttps://technologyawareness.org/ resource for staying informed on the latest tech trends and developments. With a user-friendly interface and a wide range of to...

The official website of the Embassy of Ghana in Israel,https://ghanaembassyisrael.org/ provides a comprehensive platform for fostering diplomatic relations and strengthening ties between these two ...

RPi 4 does not support 60HZ, you need to use the correct EDID

X1300 Software - Geekworm WikiI am using raspbian bookworm on Pi 4BI followed the steps from the software guide but there's an error when I tried to configure the dv timings therefore I am unable t...

Here voltages from terminal (Voltmeter says there are 5.05v and 3.33v)

Setup:  Raspberry pi 5 8gb x1009 hat Usb ssd with OS 12v 10a PSU   Ive connected gpio pins and pcie ffc On system boot appears low power alert which shutdown whole setup Try to ed...

Hey,   We would like to build a device which acts as a middle-man to a harddrive. This involves reading SATA commands from a host computer, performing some logic on the commands, and sending...

@Cindy Ding what about a quieter fan?

Hi, You can refer to the last FAQ on the KVM-A8 WiKi: https://wiki.geekworm.com/KVM-A8#FAQ Q. Does KVM-A8 support passive heatsink such as (P165-A or P165-B etc) instead of fan? ...

Yes, many devices with front panel headers, like those passing through to a Raspberry Pi, can schedule power on/off operations, though it depends on the specific model. You can check the device's m...

I recently acquired a geekworkm KVM-A8, the pci version, and it works great. PiKVM is really awesome. My only complain is the tiny fan inside. It has a tiny whine sound really noticiable at night....

Thank you for providing very useful information!

@Maurizio Imperatrice Thank you very much for this useful article!