Hi Bro! I am facing the same problem fo find any solution to this issue.

The PiKVM software images are built with support for multiple hardware models (A2, A3, A8, etc.). That’s why the kvmd-fan unit shows up on the A3, even though it isn’t functional there....

@crazy cattle 3d I’ve seen a few people swap the stock fan for a quieter 40mm Noctua or Sunon with good results. A heatsink alone might not be enough depending on your ambient temps, but a la...

Someone mentioned bc game Saudi Arabia official on a forum. I checked it out, and it seemed legit. The overall experience left a good impression.bc game saudi arabia official

Have you tried a different USB OTG cable or adapter between the Pi and the x306? Sometimes the data lines don’t get picked up if the cable is charge-only. Also worth checking if the overlay i...

Power supply issues with the x1009 can be really frustrating, especially since they often affect performance and stability. It’s helpful to check wiring and voltage compatibility first before...

Power supply issues with the X1009 can be really frustrating, especially when consistency is critical. It’s always smart to check whether the problem stems from voltage fluctuations, faulty a...

Based on your purchase of X729, I assume you're running it on an RPi 4. It is right that you purchased an X729 with a 12V input since the X728 only works with DC 5V. I am grateful for your backing....

What a fascinating problem! Could it be a startup power draw issue, possibly going over the Pi's USB current limit at first? I wonder if the boot problem could be resolved by utilizing a powered US...

This essay provides a perspective that allows us to perceive and assess reality. This essay provides detailed information and is highly instructive. Wacky flip

@ deer adventure If the KVM-A3 itself is working fine but the OLED never powers on, it could be a firmware/config issue rather than a bad connection. A couple things to try: Make sure you&rsq...

@slope Yes, you're correct that the X728 is designed to provide a battery backup and safely shut down your Raspberry Pi in case of a power outage, ensuring it can reboot when power returns.

I know. The pi works for 1-2 days. That is th reason, why I think that it is no problem with the contacts. I will try to reconnect the pi to the the X1202.  I am considering replacing the pla...

Please note: If the UPS does not detect the RPi5, it will automatically shut down within 3 seconds. So you need to install the RPi 5 on the UPS and make sure that the RPi5 has good contact wit...

Hello, my raspi 5 and the X1203 works. The voltages are ok and I have connection via i2c. Every day the raspi is down. There are no entries in the logs. On the X1202 the led 5V and Pi are off. I...

Found some information and got it working: Set file system to read/write with rw Added this to /boot/config.txt:dtparam=i2c_arm=on Then did this:echo i2c-dev | sudo tee /etc/modules-load.d/...

Recent purchase of KVM-A3 device, set it all up with a downloaded OS.  Everything seems to be working ok, and I can view and control a PC connected to KVM-A3, the only issue us that the 0.96" ...

Hi i have a raspberry pi5 with an x1009, i only attached 1 drive, im using a 12v 5a power source meant for LED lights, i can see the x1009 doing lspci, but the disk wont spin and the blue light als...

@geekworm Sorry, X1202 does not support your idea.

@Snow Rider 3D I ran into the same confusion with a UPS HAT (not sure if it was V3), and the GPIO mapping tripped me up. On my Pi 4, GPIO6 (BCM) wasn’t the same as physical pin 6, and the wik...