X1300 Software - Geekworm Wiki
I am using raspbian bookworm on Pi 4B
I followed the steps from the software guide but there's an error when I tried to configure the dv timings therefore I am unable to set the settings to 1920x1080. 
I only managed to capture output of 1280x720@60
May I know how can I solve this problem?
RPi 4 does not support 60HZ, you need to use the correct EDID
Even if I changed to the 1080P50EDID the format still seems to stuck at 1280x720, after I rebooted both the source device and the device mounted with X1301.
Please set the HDMI signal source to 1920@1080P and try again.
I just tested it again, using my laptop as the hdmi signal source. Once I set the resolution of the laptop to 2880@1800, the output result is the same as yours. However, when I change the resolution of the laptop to 1920@1080, the output result is as follows:
Hi, I managed to set the format to 1920x1080@50 
however when I try to capture there's an error occur which tells me select timeout.
I managed to capture the csitest.yuv file if I change the format to UYVY but when I try to play it is says that the file is corrupted. 
