@Deloril I had the exact same experience!!  I struggled to figure out wth was going on.  Brand new Pi5, and no 36 - googled, found your post, took a q-tip and 99% iso and rubbed the crap ...

I have just re-installed my script from 5 years ago on a raspberry pi 3b+ running on bullseye and it's nice to see that this script still works perfectly, although with some minor modifications. 😀

@deer adventure This latency can fluctuate depending on the specific configuration and the processing capabilities of the integrated system.

Internet Connection Dropping Frequently. Your fnaf Wi-Fi or wired internet keeps cutting out, making it hard to work or play online. What usually makes a CPU overheat?

@Harry Huang, the pins are marked as used

Did anyone find a fix for this, because I am also having the same issue; I have re-seated the pins multiple times but get that same set of dashes from i2cdetect? EDIT: I did find a solution; despi...

The PI ZERO 2W only supports USB 2.0, so it does not support the UASP protocol. However, the X301 hardware itself supports UASP. Please understand.

You should check if the Pimoroni Hyperpixel Touch is actually using GPIO 6 and GPIO 16.

Thanks for your sharing. 👍

Was wondering if there is a portable power solution for the Raspberry pi 5 that doesen't interfere with gpio signal. I would like to use a screen like the pimoroni hyperpixel touch which uses all t...

Hi, I have https://geekworm.com/products/x301 attached to a RPI Zero 2W, with latest Raspbery PI OS. On the product page it says: Supports USB Attached SCSI Protocol (UASP) however when I lo...

This is very likely a hardware issue in the battery path, not a software problem. Key signs: BATT_V = 0.003V → the PMIC does not see the battery at all, even though each cell measures ~4...

Sounds good. @time

I think I've found the answer. If you read /boot/firmware/overlays/README you will see this: ```        fan_temp0               Temperature t...

I bought a couple Active Cooler H505 blowers for Raspberry Pi 5, and they work well. There is one curious detail that I cannot explain. I have Prometheus recording the vital stats of several syste...

tried your commands but it does not work in my case !

hello.  i have rpi5 16b model and have newly bought Geekworm X1004 Dual M.2 2280 NVMe HAT from robu.in and i have 2 nvme 1 tb crucial p3 plus and second nvme 2 tb p3 crucial plus nvme both wo...

Hello! However, this can increase if: The host/driver introduces buffering or frame-synchronization delays. Edit by: Drift Boss last 1 day ago!

-

If I understand correctly: you want to auto-on when power is supplied, and use a button to turn it on/off — in my opinion you can: turn on auto-on, and use a momentary switch to shutdown. But...