thanks

I tried poki free games and the experience felt lighter than I expected. The site loads quickly the games start instantly and the whole rhythm stays calm which makes it easy to play during short br...

I want to use these upgrades to develop gaming software, it seems to be optimized for use

I have a KVM-A8. I have successfully modified the hardware so it runs on rpi 5 (replaced the CSI cable with a rpi5 camera cable, as the HDMI capture card emulates a camera) AND (replaced the fan wi...

Hi, My X1202 stopped charging the batteries. The battery indicator is always 4 bars on the LED. I checked the batteries invidually using a multimeter and they all have 4+ V, however battery volata...

I've just installed the X651 with CM4002000 and flashed the image- the problem is, the raspberry receives an ip address but I cannot ping it or see the web interface.  The leds on the board s...

Hi everyone, I have a project that uses a BOE MV315QUM-N20 32" 60HZ 4k panel. My end goal is to be able to switch between a LVDS source and a HDMI source and display the selected input to the pane...

Found the issue - Ribbon wire was faulty. Changed that, and it is now working. 

Hi, I was excited to recently get a X1004 to experiment with. I already had NVMe and PoE+ for RPi5 from HackerGadgets that I have been successfully using with a Coral Edge TPU (similar to hailo-8)...

Hello, I have bought X1002 few days ago on amazon.de. I didn't read before that problems could occur with different SSD. Now I am wondering would it be OK just to buy original SSD from raspberryPi ...

Hi I’m in the process of building a NAS and in the stage verify the components and that they will work together. It’s not any of the ordinary but I need to verify that my spec correlat...

The fan suddenly got a lot louder, so I need to replace it. Please advise on which fans would fit either from this store or from amazon.de or just provide the fan measurements and connector type wh...

If modifying the on‑board is too risky or not possible, one could build an external circuit that, at power input, briefly pulses the power button contacts (via a transistor or solid-state device) t...

thanks for help!

Has anyone had issues with the KVM-A8 not switching a motherboard on/off? I've got a few of these KVM-A8(s), and it is only on my Gigabyte Server motherboards that it's happening on.    

@crazy cattle 3d I’ve seen a few people swap the stock fan for a quieter 40mm Noctua or Sunon with good results. A heatsink alone might not be enough depending on your ambient temps, but a la...

Have you tried a different USB OTG cable or adapter between the Pi and the x306? Sometimes the data lines don’t get picked up if the cable is charge-only. Also worth checking if the overlay i...

@ deer adventure If the KVM-A3 itself is working fine but the OLED never powers on, it could be a firmware/config issue rather than a bad connection. A couple things to try: Make sure you&rsq...

@slope Yes, you're correct that the X728 is designed to provide a battery backup and safely shut down your Raspberry Pi in case of a power outage, ensuring it can reboot when power returns.

I know. The pi works for 1-2 days. That is th reason, why I think that it is no problem with the contacts. I will try to reconnect the pi to the the X1202.  I am considering replacing the pla...