@Harry Huang I have the same question.  WHY does it have two inputs?  Can I hook two DIFFERENT inputs and have one output?  How do you switch between the signals?   Thanks

@Harry Huang Thank you...just curious though as to why...are there 2 just in case one does not work? If you have two devices each with their own LVDS signal, would I plug both up to each port? ...

Hello, I am considering buying an X829 board with my raspberry pi4. I am currently running Fedora IoT on it. I am wondering about software compatibility issues with that board, or other like the X...

@Harry Huang I did a complete reflash using Debian ARM64.

@Mal D  Hi,  'do a complete OS reinstall on the Pi.' I understand that you re-flash your TF card, or only update your raspberrypi os via 'sudo apt-get update'? Regards,    

Hi, Thanks. There are 2 way input.

I purchased an x728 UPS hat several months and got it set and running with an RPi 4. It worked great for a few months until I needed to do a complete OS reinstall on the Pi. This time when I tried ...

Hello...just have a question about the two LVDS input ports on teh LVDS to HDMI board. Are they both used for input? Is on for input and the other for output? Just curious why there are two. Thank...

I've been able to pinpoint a possible cause, whenever I power the RasPi4 with the X832 and the provided cable, the HDD is not detected. If that cable is disconnected and I use the USB-C power suppl...

That is exactly the way I'm using it, except I don't have the X735. I thought the USB jumper might be the problem, so I ordered a male-male cable from amazon, and it still doesn't detect the drive....

Hi, Severy key points: 1. Format your new SSD/HDD;  2. Replace the USB connector / JUMPER with USB 3 cable; 3. Use 5G wifi not 2.4G wifi 4. DON'T use metal case if you want to use 2.4G wi...

hi,  Thanks you very much. Pin to Top;  

Hi,  I think your idea is achievable,  X735 only provide the 730off command to achive save power off, but no X735reboot.   Chrontab  + reboot  

Hi, Sorry for late reply. Only one X735 can meet your request. Thanks.

hi, Please refer to :

Hi, Thanks for your support. The correct power way is TYPE C port or DC 5525 Jack in X728 Hat, we don't use micro USB because of the low current limit of the micro USB connector (Max. is only 2.5A...

The documentation for the X728 states not to use the micro usb to power the pi, or to use the USB-C port. I am however quite confused by this. What is the proper way to charge the batteries in the ...

I'm having similar issues, but I don't think PSU voltage is the root in my case. I bought the kit that includes X832, metal case and 12V@5A PSU, therefore I assume voltage issues are out of questio...

This Forum is complety dead or what?, I think I find a whay of doing what I whant with only 1 component

@Marco Dittmann Hi friend, Please refer to the PCB layput of T208: https://raspberrypiwiki.com/T208#/media/File:T208-PCB.png Hope it will help. Best regards, Cindy/Geekworm