Hi, The T208  UPS (https://geekworm.com/collections/nvidia/products/t208-18650-ups-max-5-1v-8a-output-power-management-expansion-board-for-nvidia-jetson-nano) looks awesome and I'm very much ...

Hi, The 2 extra 5v ports on the X835 I received don't seem to work. I wanted to add 2 25mm fans to the back of the x835 case, but the fans don't work when plugged into the ports. They show to be a...

Hello everyone, I'm trying to run 3 stepper motors using a raspberry pi 4 and two of "Geekworm's Raspberry Pi full function motor hat robot expansion boards". I recently found out that in order to...

We will update the X735 on the next bulk, will solve this question.

@Thomas P  Hi, when AUTO ON is enabled, the safe shutdown function no longer works.   Regards,    

@james mutch  Hi,  Sorry for some of the problems you encountered.   1. About wifi and BT, We think this does have some problems. A large number of signals generated by usb 3 hig...

Before you read on i have submitted an email to Cindy in hope that something is either faulty or simply a bad manufaturing design or simply incompatible setup that is causing major issues.   ...

I am having a similar issue. I don't have any jumpers on the function header. I have the external momentary switch connected. I can power on or hard power off, the reboot and soft power down do not...

@Ugo Tognazzi Apparently, there is some mention of this problem over in the blog: https://geekworm.com/blogs/news/some-tips-about-usb-3-0-devices

@Ugo Tognazzi You can add the X862 to the list. I spent 2 days tracking down what the issue was. Frustrating!

@Aiden Ralph  Hi, Thanks   The press time is related to the firmware of the MCU,  The purpose of pressing 3 seconds is to prevent accidental shutdown

Also can i use a harddrive ide cable to do that because it look like the raspberrypi 40 pin cable but white it look like that: https://www.amazon.ca/-/fr/Disque-40-broches-femelle-dextension-Cordon...

Also can i use a harddrive ide cable to do that because it look like the raspberrypi 40 pin cable but white it look like that: https://www.amazon.ca/-/fr/Disque-40-broches-femelle-dextension-Cordon...

My question is with the x728-a2 ups hat for raspberry pi can i cnnect it via a 40pin gpio extension cable instead of direccly pluging it to the top because i make a hanheld console and i want it to...

@james mutch  Hi, welcome. You can refer to https://raspberrypiwiki.com/GEEKWORM_NAS_Family

Hi George, I ran through this thread and the x708 software wiki page and started again. Your script works when i pull the power adapter from my case and the x708 shuts down :) Is there anyway to ...

Hi George, Thanks for your patience.  Because i have a different setup from yours i'm assuming this could be the problem. Your script does work when you pull the power plug out to th extent ...

Hi,  I have recently brought the X728 board for my raspberry Pi, and first of all I have to say it is brilliant! It's the only UPS I've tested that actually works correctly. I would however ...

@james mutch  Hi James The issue here is that what you want to achieve and what i have achieved are two completely different things. My script shuts EVERYTHING down ONLY WHEN THE POWER SUPP...

I tried wrapping the whole X872 board but it doesn't even boot that way, probably it shorts something, so I tried wrapping it in a more careful way, it booted but nothing changes. Also I don't feel...