Note, the kvmd-fan code to fix the PWM mode is on the "pwm_mode" branch of the forked repository linked above.

The 30mm fan that comes with the A3 kit is only a two wire fan, and is connected directly to 5V power.  It runs at full speed all the time.  However, with a little mod, you can get a PWM ...

You are absolutely right, I recently saw such a case, if I see it again, then I will share the resource

If you have documentation or libraries provided by the x728 UPS manufacturer to interact with it via Python, you should refer to that documentation or official resources for information on how to g...

The error you received may be because the python-smbus package is missing from your repository or is not available for installation from standard sources. The package may be available from another ...

Similar problem here.   However, I see no PCIe light on the 1001 (but the SSD LED is blue) and lspci only shows: 0001:00:00.0 PCI bridge: Broadcom Inc. and subsidiaries Device 2712 (rev ...

since there was no reply to this, I ended up picking up the Pimoroni NVMe Base for Pi 5 and it worked flawlessly, and with far fewer commands! You simply write an SD card, boot, get latest eeprom u...

@Kevin Sporinsky Where can I find the answers to your questions? I have the same questions.

For optimal cooling with the Gemini x882, consider Cooling Solution for a stellar performance. But here's a pro tip – while you're optimizing your setup, take a moment to dive into the coolin...

@Peter Schneider  Did you ever solve this issue? I'm fairly picky with noise and this device seems well priced but I don't need to have a whine coming out of the study, my wife will kill me.

@Kevin Sporinsky It is possible without LED display. It is easy to do if you apply what I wrote.

@Maurizio Imperatrice thank you! The `PCIE_PROBE=1` parameter was key for getting me to a point where the device would boot from NVMe. It worked! For a moment... --- I have the X1001 board and se...

@JinGyu Choi Were you able to get this to work?  I'd like to do this as well.

Hello. I appreciate your engagement with the X680 and ATX modules discussion on the Geekworm community forum. It's fantastic to see users collaborating and sharing insights.If you're ever in need o...

1. In fact, the pi 5 will boot from sd card even  if you still insert the TF card. 2. The PI 5 BOOT_ORDER  configuration is stored on the EEPROM of the PI 5 motherboard, and it not be ch...

Seems I solved the issue! In another guide I found another line to add to rpi-eeprom-config, this is what I did: sudo rpi-eeprom-config --edit Added as the first line of the file PCIE_PROBE to...

On December 15 I bought on Aliexpress "X1001 M2 Shield". Everything works fine if I boot from SD, but I can't boot from SSD. I followed your procedure on this page: https://wiki.geekworm.com/NVMe_S...

When selected, the switch turns green.

nano /etc/kvmd/override.yaml kvmd: gpio: drivers: switch_input_1: type: cmd cmd: [/usr/bin/bash, /etc/kvmd/scripts/switch_input.sh, 1]...

Hi Not sure if i understand correctly but what i need to do for my Geekform PIVKM to act like mouse and keyboard.  I have not plugged anything to OTG and not quite sure if i need to plug some...