Hey,  In my project, when the main power is down, I want the Raspberry pi to show a message, close some programs safely, and then shut down. Then, once I connect the main power again, the pi ...

@Shehan Fernando  Hi， What power supply are you using? Could you please send us a test video? Thanks

@Lisa ZHANG Thanks for the reply. But even with one HDD attached, 3.5 hard disks not working. Here are the Hard disks I have tried. Both of these Hard disks are not recognized.  2nd hard d...

Hi， Please use the same type of hard drive,HDD+HDD or SSD+SSD； an error will be reported when using SSD+HDD.  PS：It is recommended to use an SD card to install the system.

I bought an x880 to build NAS with my Pi4. I was planning to attach one 2.5 Laptop hard disk and a 3.5 Desktop hard disk. But unfortunately, the 3.5 desktops hard disk is not detecting. A blue ligh...

Hello， Thanks for your interest in the Geekworm products, but there is no a HDMI to CSI-2 Module compatibility with Jetson yet.

Hi all, i saw that the C790 (HDMI to CSI-2 Module) have all the configuration to be used in combination with Raspberry, but i need to use it with a Jetson Xavier or Orin. Does anyone know if there ...

@Bas I Hello， Thanks for your valuable advice.  1/Our initial design is an ultra-thin and compact case. Considering the thickness of the aluminum radiator, we need to increase the heigh...

Very nice and sleek looking solution. While assembling i bumped into 2 issues; 1- Leave a bit of room for a cooling block (or build it included in the fan bracket) 2- There is no opening for the ...

Alas Lisa, you are correct again <sigh>. The covers and button arrived this afternoon and it does not fit. I recently bought some transparent filament. I will try to design and print a larger...

@Frederick Brier  Geekworm switch size is 19mm, I think 16mm Switch Cover should not fit it.

I decided to go with Geekworm's momentary switch and I found a "DaierTek 16mm Dustproof Safety Push Button Switch Cover Guard Plastic Protector" cover on Amazon, which I hope will work with your pr...

@Frederick Brier  XH2.54 5V OUT connector also not support the latched switch（it’s 4pin connector）. If you want to use an external switch, it is recommended that you buy a momentary swi...

So I see on the Update notification, "Remove the latching switch connector(the latching switch is no longer supported and replaced by a XH2.54 5V OUT connector". The reference to XH2.54 5V OUT...

Going from v2.5 to v3.0 of the x735, the 4 pin header appears to have repurposed pins 3 & 4 from "Using external latching switch" to "PWM fan is controled by GPIO, need to install script". Does...

@Lisa ZHANG Thank you! I did search, just not that term.

@Frederick Brier  Hello， DC Barrel positive tip.      If you try to search [positive] on the wiki page, you will find an answer.  

On my x735 v3.0, I don't see any polarity graphic for the DC 5521 on the top of the circuit board, the bottom, or the connector, nor can I spot it in the documentation. Is the tip positive, or nega...

I missed section 6. Thank you.

Hello， please refer https://wiki.geekworm.com/X735_Hardware