a couple of years ago i bought a geekworm  ssd expansion board which came with that usb connector.  that connector inspired me to find a similar u shaped usb adapter to use with my new KV...

Discover cutting-edge EdTech tools at EduTechBuddy. Elevate your learning experience with their dynamic range of educational resources. Visit now to unlock a world of possibilities in education and...

I created a new topic with my very similar problem here: https://geekworm.com/community/forum/topic/119225/kvmd-fan-not-functional-with-pikvm-a3 Enabled kvmd-fan but it does not limit my fan speed.

I installed the KVM-A3 and so far it works fine. One thing that does not work is the fan control. The fan is always spinning on high velocity, creating a lot of noise. I enabled the fan control l...

@brix maxx I'm actually working on this right now.  I'm the original poster and for some reason can't put new replies on my old account so I started a new one.  While I don't have the ori...

@Mark Berndt This is great.  Any chance you think there's a way to also make the PC Input dropdown show LEDs that indicate which input is selected?  Looks like your sciprts only pass CTRL...

@Harry Huang  1) Can the input be switched thru a GPIO command (and not just ctrl-ctrl-x)? The PC input can be switched via the GPIO webterm menu feature of PiKVM: add the following to /etc...

Hello, how much latency can i expect from the HDMI to CSI-2 Module with Toshiba TC358743XBG chip C790 ? Thank you

I need to build a harness to mate with the "+5V IN" connector on my X703 UPS. Does anyone have connector and contact part numbers?Thanks

Yes, the input can be switched through a GPIO command. In Raspberry Pi, you can use the GPIO utility to manipulate the pins and switch the input/output mode. For example, in PSUControl switching sy...

The auto power on function has nothing to with switch. trasteros barcelona

lease be cautious when modifying scripts related to power management, as improper changes can potentially lead to data corruption or other issues. Make sure to back up your data and configurations ...

Hello, I am trying to add an HDMI port to an embedded device with a 12" 1280x800 LCD panel. It uses a 20 pin LVDS connection. I can connect it to other screens and it works. However, I cannot get ...

The ideal strategy depends on the particular devices and whether it is possible to modify the scripts or wiring. To begin with, I'd see if the UPS could be modified to use any other GPIO than 18 fo...

Any assistance would be greatly appreciated. I got this result when executing a fan control script on Raspbian. Carefully consider the file path to the ppm_fan_control.py file and all other files y...

found the culprid it was the included 30cm hdmi cable that had the problem. after using a different cable everything is working.

[ 12.974083] mc: Linux media interface: v0.10 [ 13.013149] videodev: Linux video capture interface: v2.00 [ 13.036612] i2c_dev: i2c /dev entries driver [ 13.046317] systemd-journald[250]: Received ...

biuld it based on the howto video but it is not working. the video is not detcted. is there a way to show if the capture device is working. the other cracy thing is the pacakge looked used when...

Verify that the SSDs are functioning appropriately. To accomplish this, look for any SSD-related error messages in the system logs. You may also try badland attaching the SSDs to a different device...

do i have to use the case that comes with this if not could i possibly add a ups hat?