can i use a x1009 and 1 or 2 x-ups1 | Geekworm's Forum
  1. Forum
  2. Pre-Sales Questions
  3. can i use a x1009 and 1 or 2 x-ups1

can i use a x1009 and 1 or 2 x-ups1

  • MP

    hi i am asking if i could use rpi5 16gb to make a nas with built in battery like

    x1009 with 5 sata ssd a raspberry 5 16g  with 1 or 3 x-ups1

    the x-ups1(s) would be to run the nas atleast 30 min to 1 hour in case of power failure

    I know the x1009 needs 12v about 10amps or less to run 5 2.5 inch sata ssd

    and usp1 can only poduce 12v 3amp i also found a 12v 12amp psu that might power setup

     

    0 likes
  • HH

    You can stack multiple X-UPS1s to increase the current

    0 likes
  • e

    Using an X1009 together with one or two UPS1 boards should work electrically, but the main limitation is how the UPS1 modules share load and charging current. If both UPS1 units are connected, you’ll want to confirm whether they can balance properly or if one ends up doing most of the work

    0 likes
Please login to reply to this topic!

Participants