@Ugo Tognazzi You can add the X862 to the list. I spent 2 days tracking down what the issue was. Frustrating!

@Aiden Ralph  Hi, Thanks   The press time is related to the firmware of the MCU,  The purpose of pressing 3 seconds is to prevent accidental shutdown

Also can i use a harddrive ide cable to do that because it look like the raspberrypi 40 pin cable but white it look like that: https://www.amazon.ca/-/fr/Disque-40-broches-femelle-dextension-Cordon...

Also can i use a harddrive ide cable to do that because it look like the raspberrypi 40 pin cable but white it look like that: https://www.amazon.ca/-/fr/Disque-40-broches-femelle-dextension-Cordon...

My question is with the x728-a2 ups hat for raspberry pi can i cnnect it via a 40pin gpio extension cable instead of direccly pluging it to the top because i make a hanheld console and i want it to...

@james mutch  Hi, welcome. You can refer to https://raspberrypiwiki.com/GEEKWORM_NAS_Family

Hi George, I ran through this thread and the x708 software wiki page and started again. Your script works when i pull the power adapter from my case and the x708 shuts down :) Is there anyway to ...

Hi George, Thanks for your patience.  Because i have a different setup from yours i'm assuming this could be the problem. Your script does work when you pull the power plug out to th extent ...

Hi,  I have recently brought the X728 board for my raspberry Pi, and first of all I have to say it is brilliant! It's the only UPS I've tested that actually works correctly. I would however ...

@james mutch  Hi James The issue here is that what you want to achieve and what i have achieved are two completely different things. My script shuts EVERYTHING down ONLY WHEN THE POWER SUPP...

I tried wrapping the whole X872 board but it doesn't even boot that way, probably it shorts something, so I tried wrapping it in a more careful way, it booted but nothing changes. Also I don't feel...

i've already done the sudo chmod 755 xxx.sh with file. Is there a way to double check it does have permission? i have also done the reboot after everything you suggest but the x708 does not shut of...

try to use USB 2 port to Flash dongle or 3G dongle?

Hi, This is the EMC brought by USB 3, you can refer to https://raspberrypiwiki.com/images/5/53/Usb3-frequency-interference-papers.pdf; Normally, 5G AP can be connected. Try to cover the copper f...

Hi I got my X728 board and have a question I would like to power on the board using an external signal (from an other system). Is any pin out (switch) on the X728 able to start this power-on on d...

Hello   X828 attached to Pi 3, powered by X710. works. HDD works fine   but none USB 3 port works with Flash dongle or 3G dongle when plugged in X828 (LSUSB does not detect anything)....

@Harry Huang  I was not talking  about external switch but the PCB switch . it simply does not work   Tx

As the title says when using my Raspberry Pi 4 with X857, X872 and X735 the Wi-Fi doesn't connect to anything, I tried both 2.4 and 5 GHz, they are detected correctly but it just doesn't connect. ...

@james mutch  My script posted yesterday should turn the pi AND the x708 off. Hence something else is amiss. The rc.local file should only contain: /home/pi/shutdown.sh echo ds1307 0x68 &g...

Hi, I've installed the script and hashtagged all the lines that were in rc.local apart from the last 3. It looks like the shutdown part works after 30 seconds when i pull the power adapter out but...