No Products in the Cart
Alas Lisa, you are correct again <sigh>. The covers and button arrived this afternoon and it does not fit. I recently bought some transparent filament. I will try to design and print a larger...
Alas Lisa, you are correct again <sigh>. The covers and button arrived this afternoon and it does not fit. I recently bought some transparent filament. I will try to design and print a larger...
I decided to go with Geekworm's momentary switch and I found a "DaierTek 16mm Dustproof Safety Push Button Switch Cover Guard Plastic Protector" cover on Amazon, which I hope will work with your pr...
So I see on the Update notification, "Remove the latching switch connector(the latching switch is no longer supported and replaced by a XH2.54 5V OUT connector". The reference to XH2.54 5V OUT...
Going from v2.5 to v3.0 of the x735, the 4 pin header appears to have repurposed pins 3 & 4 from "Using external latching switch" to "PWM fan is controled by GPIO, need to install script". Does...
@Lisa ZHANG Thank you! I did search, just not that term.
On my x735 v3.0, I don't see any polarity graphic for the DC 5521 on the top of the circuit board, the bottom, or the connector, nor can I spot it in the documentation. Is the tip positive, or nega...
The X735 v3.0 appears to passthrough all the GPIO Pins on the Raspberry Pi 4B. Obviously you should not use pins used by the X735. What pins does it use? Another post mentioned Pins 4, 17, 18, but ...