Well the title pretty much says it all. I am wondering if the X829 will support a two drive raid 1 array?

I'm pretty new to all of this but I want to make a NAS server for my family.  Ideally, what I want is for each person to have their own drive (5 in total) for their personal use (mainly to str...

Hi, Unless there is something else going on that I misunderstand, this is not my issue. I am having an issue with the batteries not staying charged even when plugged in with a more than capable po...

@li xia  That is what I expected the Blink Status to mean, However I wanted to verify. Thank you. As for the issue that I am seeing, I ran a few tests and have a bit of further information o...

Thanks for your time!

Also, and sorry for being so chaotic: what if I use a 10-pin cable to connect them?

@li xia Huh, OK, thanks for the reply. So a followup question would be: is there a dedicated case that might fit both the Jetson Nano and the T208?

I am seeing the CHG LED blink for a period of time, then it will stay constant for a few minutes and then start blinking again. This blinking feature does not appear to be documented anywhere and I...

Hi, The T208  UPS (https://geekworm.com/collections/nvidia/products/t208-18650-ups-max-5-1v-8a-output-power-management-expansion-board-for-nvidia-jetson-nano) looks awesome and I'm very much ...

Hi, The 2 extra 5v ports on the X835 I received don't seem to work. I wanted to add 2 25mm fans to the back of the x835 case, but the fans don't work when plugged into the ports. They show to be a...

Hello everyone, I'm trying to run 3 stepper motors using a raspberry pi 4 and two of "Geekworm's Raspberry Pi full function motor hat robot expansion boards". I recently found out that in order to...

We will update the X735 on the next bulk, will solve this question.

@Thomas P  Hi, when AUTO ON is enabled, the safe shutdown function no longer works.   Regards,    

@james mutch  Hi,  Sorry for some of the problems you encountered.   1. About wifi and BT, We think this does have some problems. A large number of signals generated by usb 3 hig...

Before you read on i have submitted an email to Cindy in hope that something is either faulty or simply a bad manufaturing design or simply incompatible setup that is causing major issues.   ...

I am having a similar issue. I don't have any jumpers on the function header. I have the external momentary switch connected. I can power on or hard power off, the reboot and soft power down do not...

@Ugo Tognazzi Apparently, there is some mention of this problem over in the blog: https://geekworm.com/blogs/news/some-tips-about-usb-3-0-devices

@Ugo Tognazzi You can add the X862 to the list. I spent 2 days tracking down what the issue was. Frustrating!

@Aiden Ralph  Hi, Thanks   The press time is related to the firmware of the MCU,  The purpose of pressing 3 seconds is to prevent accidental shutdown

Also can i use a harddrive ide cable to do that because it look like the raspberrypi 40 pin cable but white it look like that: https://www.amazon.ca/-/fr/Disque-40-broches-femelle-dextension-Cordon...