Thanks, it was userful information, cause it helped me to solve the simmilar issue.

I recently ordered your NasPi kit on Amazon but am running into a big problem. The raspberry pi is not detecting the 2.5 HDD that I plugged into it with your board. I have the 1.5 version board wit...

Thank you for this post! if you want to write it on your instagram too you can use this site https://soclikes.com to get a lot of likes

Hello，Tony Sorry for the inconvenience, What brand of hard drive are you using？could you please send some test pictures and video by email ？【support@geekworm.com】；and please let us know your order...

I purchased the X857 V2.0 from Amazon. I connected a new mSATA (also purchased from Amazon, and yes the mSATA drive works!). I attached the board to the Raspberry Pi 4 with the included standoffs. ...

  source： https://www.raspberrypi.org/forums/viewtopic.php?t=245931 We have seen reports of extremely degraded performance when using several types of USB3.0 to SSD adapter or when using nat...

Hello，Brent could you please send some installation pictures by email?  and please tell us your order number.thanks.       support@geekworm.com Best regards

Hello， X708 ups cannot be used with X750 ups.  

Sorry for adding a second post, but due to the pandemic, it takes a long time, after it gets to the States, so ordered a lager coolong fan from Amazon, see attached photo:   It is a DV:5v ...

Originally I purchased an x829 with the x735 hat. I did get it working but a couple of days later I received my X708-A1 battery holder and the x708 hat. I fully assembled the unit with the x829 on...

Puis-je utiliser deux X708-A1 et un x750 ups sur une seule carte ups X708 ?

Needed to install git...   

trying to install x735 v2.5 software on RPI 4 - 64 gb and have run into a problem, see below. Not sure what to do as I cant get the cooling fan to work? pi@raspberrypi:~ $ sudo apt-get install pig...

Hello，Because it is a UPS expansion board, please use the battery in accordance with the safety warning.  and please pay attention to the heat dissipation problem to avoid the safety problem o...

I'm running an x728 on each of two raspberry pi 3 b+.  Amid all the warnings about charging the LiPo batteries in a fireproof box, I'm wondering if I should be keeping my pi+x728's in an ammo ...

@TefaTBob  Hello,sir We have not encountered such a problem, could you please send us some test videos by email? 【support@geekworm.com】 Our engineers will refer to the video and try to find...

Hi, This is my second x728 (1st wouldn't charge). The x728 works great when plugged into a 5V power source, but when I switch to batteries, the rpi 4 seems to boot, but there is barely any power g...

@Brent Engle  Hello， yes，you can use X708 ups hat for x829 and pi 4； two batteries are enough If not need more current Installation video for Raspberry Pi 4+X829+X708/U100+X829-C1 : https:/...

I think I found my answer in https://geekworm.com/community/forum/topic/13068/usb-boot-x829-x735-x829-case X708 UPS and X708-A1 Battery holder. Will use the X735 on Raspberry PI 3b we have as well.

Hello, I have a similar situation. I have a: Raspberry PI 4 64 bit.  (1) 1 TB sata hard drive and (1) 250 gb sata hard drive I have recently purshased X829 Dual 2.5" SATA SSD/HDD Storage...