Hello， X880 does not support power management.

Does X880 with two disks on radi1 supports power managment with spindown option?

It works, but I'll give your other suggestions for shutting down the pi a shot first!     dordle

@Nicolas Ochem  Hello， Thanks for your feedback and suggestions. It needs to add a usb hub chip, but there is no room for another USB accessory on the X728 board. You can use the 5V Out XH...

Hi, I have been very happy with X728! I am using it with a USB security module which requires PIN at boot time. I have one problem: when I software reboot the Raspberry Pi, the USB port briefly l...

@Yulia Marid Hello， Do you want to install PiKVM-A3 kit? Could you please provide more details? so that we can provide you with any assistance.

@howar dellis  Hello， What version is your x728 HAT? Could you please provide more detailed information? For example some test pictures or videos. Thanks.

@charles trevino  The X828 can be stacked, but it has been discontinued.

Please leave message here if you have any questions, but we still recommend carefully reading official documentation firstly.

Hello，sir  Sorry for the inconvenience, and thank you very much for your suggestion, we have updated it（X728-hardware#Pins and GPIO used）.  https://wiki.geekworm.com/X728-hardware Best ...

The fact that pin33 (which is listed in the pinout table on https://wiki.geekworm.com/X728-hardware has been changed to pin37 is not listed in there. Please fix this it took me and others way too l...

Hi, have you considered reinstalling the OS on the SSD? Then see if the function is normal?

@Nathan Dilgard  Hi， Thanks. Which OS? Or you can place the following line in the /etc/rc.local sudo pigpiod python ./x-c1/fan.py & or use the another method: How to add crontab job ...

Evertime I reboot my Pi incased in the X-C1 I need to run the blow steps in order to get the fan to run: sudo killall pigpiod Must run or I will get an error when I try and  run python ....

I have installed the NASPIcase  and it works beautifully, running Ubuntu server without issue.   My installation was performed on an SD card, but I want to boot from SSD. To migrate...

@Lisa ZHANG Interesting new development, the one drive is showing up like a usb drive now.

@Lisa ZHANG I removed the X735 and still have the same results. Only one drive shows up. Below is an fdisk -l readout $ sudo fdisk -lDisk /dev/ram0: 4 MiB, 4194304 bytes, 8192 sectorsUnits: sector...

@Lisa ZHANG I don't have the equipment to take a video but I can tell you that I formated one drive and labeled it so that I could tell after switching locations if it was a drive issue or if there...

Hello，Nik Please try to download this system and test it.  https://downloads.raspberrypi.org/raspios_full_armhf/images/raspios_full_armhf-2021-05-28/

Hey there,I've been trying to install the X630 on my Raspi 2B V1.1 with Raspian Buster using these instructions for installation with hardware reset. Trying to start "raspistill" or "raspivid", I'm...