Anyone know wire connection of switch to button? I want to connect a button with C-NC-NO, not official button. With the small blue button it works to restart with 3 seconds press. But I have tried ...

Thank you for the prompt reply.

Hello，Alex The X820 case has Micro USB and USB-C port, please rest assured to buy.  The image shown by Amazon is an old version. And we'll update the correct image right away. Thank you for y...

Hello! The X820 V3.0 case, SSD board, and X735 board combo kit for sale on on Amazon comes with a USB-C supply, but the X820 case photo only shows an opening for the MicroUSB port on the X735. ...

Hello everyone,Here is what happened for whoever is interested in knowing how it worked for me.  After contacting the support team, they tried the exact same setup (same PI, OS, and HAT) as t...

Hey,  In my project, when the main power is down, I want the Raspberry pi to show a message, close some programs safely, and then shut down. Then, once I connect the main power again, the pi ...

@Shehan Fernando  Hi， What power supply are you using? Could you please send us a test video? Thanks

@Lisa ZHANG Thanks for the reply. But even with one HDD attached, 3.5 hard disks not working. Here are the Hard disks I have tried. Both of these Hard disks are not recognized.  2nd hard d...

Hi， Please use the same type of hard drive,HDD+HDD or SSD+SSD； an error will be reported when using SSD+HDD.  PS：It is recommended to use an SD card to install the system.

I bought an x880 to build NAS with my Pi4. I was planning to attach one 2.5 Laptop hard disk and a 3.5 Desktop hard disk. But unfortunately, the 3.5 desktops hard disk is not detecting. A blue ligh...

Hello， Thanks for your interest in the Geekworm products, but there is no a HDMI to CSI-2 Module compatibility with Jetson yet.

Hi all, i saw that the C790 (HDMI to CSI-2 Module) have all the configuration to be used in combination with Raspberry, but i need to use it with a Jetson Xavier or Orin. Does anyone know if there ...

@Bas I Hello， Thanks for your valuable advice.  1/Our initial design is an ultra-thin and compact case. Considering the thickness of the aluminum radiator, we need to increase the heigh...

Very nice and sleek looking solution. While assembling i bumped into 2 issues; 1- Leave a bit of room for a cooling block (or build it included in the fan bracket) 2- There is no opening for the ...

Alas Lisa, you are correct again <sigh>. The covers and button arrived this afternoon and it does not fit. I recently bought some transparent filament. I will try to design and print a larger...

@Frederick Brier  Geekworm switch size is 19mm, I think 16mm Switch Cover should not fit it.

I decided to go with Geekworm's momentary switch and I found a "DaierTek 16mm Dustproof Safety Push Button Switch Cover Guard Plastic Protector" cover on Amazon, which I hope will work with your pr...

@Frederick Brier  XH2.54 5V OUT connector also not support the latched switch（it’s 4pin connector）. If you want to use an external switch, it is recommended that you buy a momentary swi...

So I see on the Update notification, "Remove the latching switch connector(the latching switch is no longer supported and replaced by a XH2.54 5V OUT connector". The reference to XH2.54 5V OUT...

Going from v2.5 to v3.0 of the x735, the 4 pin header appears to have repurposed pins 3 & 4 from "Using external latching switch" to "PWM fan is controled by GPIO, need to install script". Does...