Note: The X850 metal case has been updated to a new verison in April 2019, please refer to bog: 2019 New Updated X850 Metal Case to be Compatibe with X860 M.2 NGFF/X870 M.2 NVMe SSD Board
This is the new design metal enclosure to install the newest X850 V3.0 extension board and Raspberry Pi 3 Model B+ (Plus), or Raspberry Pi 3 Model B, or Raspberry Pi 2 Model B or Raspberry Pi 1 Model B+.
Geekworm design this X850 V3.0 match metal case after combined a lot of customers' feedback and suggestions according to the Raspberry Pi fans' demand.
Welcome each fan's advice all around the world. If you have any advice, please feel free to contact us by email: firstname.lastname@example.org .
If you need the only X850 v3.0 expansion board, please refer to:
If you need the only X850 v3.0 metal case kit, please refer to:
If you need the X850 v3.0 expansion board+ metal case kit, please refer to:
X850 V3.0 Metal Case Key Features：
- Perfect to install your X850 V3.0 mSATA storage board and Raspberry Pi 3 Model B+/3B/2B/B+
- High quality metal material with surface galvanized process;
- Support to install super mute cooling fan inside the top cover case
- GPIO cable slot is reserved at the side face
- Round cooling holes on side face of the case, almost no weakness for your Raspberry Pi Bluetooth and WIFI signal;
- round holes at the case side cover and stripe long holes at the case button for better heat dissipation
- Case Size after installation: 9cm x 6.2cm x 4.1cm / 3.54inch x 2.44inch x 1.61inch;
This Raspberry Pi X850 V3.0mSATA SSD Storage Board + Metal Case with Cooling Fan Kit reserves all the useful ports of Raspberry Pi, it is also availble to insert a GPIO cable from the case side face from the just right GPIO slot, you can use your Raspberry Pi GPIO pin with GPIO cable or other suitable device to connected.
You can see at the side face, there are many round holes cutted to strength your Raspberry Pi Bluetooth and WIFI signal, as we have get such feeback that if use a closed metal case to install the Raspberry Pi 3, there is always problem with WIFI or Bluetooth signal, as too thick case cover will block the signal of bluetooth and wifi.
You can find that at the button of the X850 v3.0 enclosure there are also 15 pcs stripe long holes cutted for better heat dissipation. On the top cover of the case, there is a beautiful mini cooling fan hole designed to install a 3007 cooling fan.
It is very easy to install your Raspberry Pi board, mSATA SSD and X850 v3.0 storage expansion board, first you install the mSATA SSD on your X850 v3.0 board by two screws, then use the standoffs to install the X850 v3.0 with SSD under your Raspberry Pi board, next put the whole set into the button of the metal case.
How do you like this Raspberry Pi X850 V3.0 Match Metal Case with Cooling Fan Kit?
To know more about Raspberry Pi storage solution, please refer to: