All orders placed will be shipped out as usual, but delivery times are expected to be affected due to COVID-19. Thanks for your continued support with Geekworm. Read More
Power off X728 after Pi4 was shut down from software | Geekworm

Power off X728 after Pi4 was shut down from software


  • I want to put the X728 into the same state as "Force shutdown (Press and hold for >8 seconds)" but after the Pi4 was powered off from software.

    How can I power off the X728 board after the Pi4 was shut down from software (sudo shutdown -h now)?

     

    On Pi4 run -> sudo shutdown -h now -> OS/Pi4 shuts down -> X728 shuts down.

     

    I hope my explanation is understandable.

    :)



  • @Robert - Hi dear ,the details please refer to our WIKI:

    raspberrypiwiki.com/X728

    raspberrypiwiki.com/X728-Software


  • @li xia hello

    Could you tell what the GPIO5, GPIO12 and GPIO13 are used for?

    Thanks you.

     

  • @Robert - Hi dear ,pin and GPIO used please refer to the picture and url below: raspberrypiwiki.com/X728-hardware


Please login to reply this topic!
BACK TO TOP