The LEDs on the x828 board are on the "rear" of the units (assuming the USB ports are considered the front). I would like to connect external LEDs to the boards. When I removed one of the SMD LEDs, connected two wires, the external LED only shows a stautus of ON or OFF-instead of flashing activitity. Are there 3 wires to these LEDs ?
Thanks
Tom
@Tom Mynar
Hi, we think the LED of X828 is on the 'front'. you can refer to
@Tom Mynar we will email to you about LED questions.
If you're setting up an external LED on the X828, make sure to connect it to the appropriate pins for power and control. The X828 typically supports LEDs for status indicators, but it's important to check the documentation for the correct wiring and pinout.
For great gaming content, be sure to visit NintendoRoms.com and PS2Roms.org for a huge selection of Nintendo and PS2 ROMs!
