Posts made by Frederick Brier

• Does the v3.0 of the x735 still work with latched/toggle switches?

  Alas Lisa, you are correct again <sigh>. The covers and button arrived this afternoon and it does not fit. I recently bought some transparent filament. I will try to design and print a larger...

  posted in General Discussion

  FB

  Frederick Brier
  9/7/22, 12:01 PM
• Does the v3.0 of the x735 still work with latched/toggle switches?

  I decided to go with Geekworm's momentary switch and I found a "DaierTek 16mm Dustproof Safety Push Button Switch Cover Guard Plastic Protector" cover on Amazon, which I hope will work with your pr...

  posted in General Discussion

  FB

  Frederick Brier
  9/1/22, 11:35 AM
• Does the v3.0 of the x735 still work with latched/toggle switches?

  So I see on the Update notification, "Remove the latching switch connector(the latching switch is no longer supported and replaced by a XH2.54 5V OUT connector". The reference to XH2.54 5V OUT...

  posted in General Discussion

  FB

  Frederick Brier
  9/1/22, 4:32 AM
• Does the v3.0 of the x735 still work with latched/toggle switches?

  Going from v2.5 to v3.0 of the x735, the 4 pin header appears to have repurposed pins 3 & 4 from "Using external latching switch" to "PWM fan is controled by GPIO, need to install script". Does...

  posted in General Discussion

  FB

  Frederick Brier
  9/1/22, 4:24 AM
• Polarity of the DC 5521

  @Lisa ZHANG Thank you! I did search, just not that term.

  posted in General Discussion

  FB

  Frederick Brier
  8/31/22, 7:55 PM
• Polarity of the DC 5521

  On my x735 v3.0, I don't see any polarity graphic for the DC 5521 on the top of the circuit board, the bottom, or the connector, nor can I spot it in the documentation. Is the tip positive, or nega...

  posted in General Discussion

  FB

  Frederick Brier
  8/31/22, 11:29 AM
• X735 Used or Reserved GPIO Pins

  I missed section 6. Thank you.

  posted in General Discussion

  FB

  Frederick Brier
  8/31/22, 11:20 AM
• X735 Used or Reserved GPIO Pins

  The X735 v3.0 appears to passthrough all the GPIO Pins on the Raspberry Pi 4B. Obviously you should not use pins used by the X735. What pins does it use? Another post mentioned Pins 4, 17, 18, but ...

  posted in General Discussion

  FB

  Frederick Brier
  8/27/22, 2:28 PM