A quick reboot, rather than a complete power cycle, should suffice. The only thing that has worked for me is to turn off the base till, wait about 20 seconds, and then turn it back on. If the base unit is in a remote place, it will be difficult. I’m not sure why Arlo has such tight firmware upgrading policies.
https://arlofirmwareupdate.com
A quick reboot, rather than a complete power cycle, should suffice. The only thing that has worked for me is to turn off the base till, wait about 20 seconds, and then turn it back on. If the base unit is in a remote place, it will be difficult. I’m not sure why Arlo has such tight firmware upgrading policies.
https://arlofirmwareupdate.com