No Products in the Cart
1. In March 21st 2020, the N100 case has been updated to new version, the new version support both Jetson nano A02 and B01 version.
2. On October 14th,we add camera bracket for Raspberry pi official camera, can fix the camera on the top or side of the case, adjust the camera position as your requirement.
3. At the end of August 2019, this Jetson Nano metal case has been updated to honeycomb chassis case.
4. This geekworm design NVIDIA Jetson Nano case has been updated in June 8th 2019 with 3 antenna holes at the back side of the case. Please contact us if you need wholesale price.
We totally design 3 cases for Jetson Nano：N100 Case, T100-C1 Case,T300-C2 Case.
N100 Case(for Jetson Nano A02&B01 Only),
T100-C1 Case(for Jetson Nano A02 and T100 NVMe M.2 SSD Shield),
T300-C2 case(for Jetson Nano and T300 2.5 inch SATA SSD/HDD Shield).
Please choose the right case you need!
This is a metal case specially designed for NVIDIA Jetson Nano Developer Kit (support both A02&B01 version now), and it supports power switch and reset switch, and it's reserve the GPIO hole and the installation space of the fan, and easily assemble it.
The N100 case is also support to install the NVIDIA Jetson Xavier NX Developer Kit, but you will need these extra 2pcs WiFi Antenna with IPEX MHF4 to RP SMA Female Extension Cable. To use this WiFi antenna, it need to remove the buttom holder of NVIDIA Jetson Xavier NX.
we recommend that you read the introduction to the power supply in the official documentation before you assemble this case, thus you can understand deeply this case.
Please refer to : https://developer.nvidia.com/embedded/learn/get-started-jetson-nano-devkit for NVIDIA Jetson Nano.
For use with
Q1:How to assemble this NVIDIA Jetson Nano case?
A: Please refer to the picture on our wiki:raspberrypiwiki.com/index.php/N100
Q2: Is it supported to install a cooling fan?
A: Yes, it is support for fan installation, 22mm high fan installation height is reserved. It is support to install Noctua NF-A4x20 5V PWM fan. (We test this fan it is ok to use and a good choice.)
Q3: How do I use the jumper cap?
A: Because this case has a power switch, you need to disable the AUTO ON function first. Please insert the jumper cap into the AUTO ON position of the J40 pin to disable the AUTO ON function.(On the back of your board there is words " AUTO ON DIS")
Q4: Why was the MICRO SD card slot cancelled?
A: N100-V9 is compatible with both A02 and B01 versions now. We must increase the distance between the JETSON NANO motherboard and the front panel of the case to install the switch. We found that even if we kept the TF card slot, we couldn’t insert the TF card by hand or plastic tweezers, so we have to cancel this card slot;
We hope that the official NVIDIA will adjust the position of J50 in subsequent versions. For more questions, please refer to the official forum link: https://forums.developer.nvidia.com/t/stop-shipping-the-nvidia-jetson-nano-development- kit-b01-j50-is-on-the-wrong-side/112066
The NVIDIA Jetson Nano Developer Kit and antenna are not included, and the 4-pin cooling fan is not included aslo!
N100 Case for Jetson Nano
N100 Case+ 2pcs Antennas for Jetson Xavier NX
Installation Video for Jetson Nano B01:
For NVIDIA Jetson Xavier NX Developer Kit
For the Jetson Nano storage solution, please refer to blog: